Error Messages - VTech KidiZoom Smartwatch DX3 Manuel D'utilisation

Montre intelligente
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Pull up the rubber cover of the Micro-USB Port on the side of the
watch.
Insert the included Micro-USB Cable (small end) into
the Micro-USB Port on the watch.
Insert the large end of the Micro-USB Cable into a
USB port on your computer.
Once the connection is successful, you will see a
battery recharging symbol
Check
When the battery is fully charged, the charging icon will disappear and
only show the USB mode screen. Then the screen will automatically
turn off. You may then disconnect your fully charged watch from the
computer.
Note: It takes approximately three-and-a-half hours to fully charge the battery.
The actual charging time depends on the charging current, the remaining
charge in the battery prior to recharging, and the ambient temperature. The
optimum ambient temperature is 32°F - 104°F (0°C - 40°C).
CHARGING GUIDELINES
Only charge this device using the included Micro-USB Cable connected to
a computer. Do not charge using a third party adapter. Before use, inspect
the cord to confirm that it is in good condition and that there are no breaks
or exposed wires. Ensure there are no particles or liquid (water, juice, etc.)
in either of the connectors before plugging in either end of the cable. The
device should be completely dry with no debris in the cable connectors
when charging. Plug in the cable securely, in the correct orientation. If the
device is on when plugged in, a dialog box may pop up on your computer to
allow you to access the device's drive. Never leave the device unattended
while charging. Do not charge your device on soft surfaces, as they can trap
heat around the device. Typical charging time is approximately three-and-
a-half hours if the battery is fully depleted. Disconnect the device when it
is fully charged. Do not leave the device charging for more than four hours.

ERROR MESSAGES

1
7
the
charging
Master Power Switch Is Off
Slide the Master Power Switch to the On position before
charging the battery.
appear on the watch screen.
progress regularly throughout recharging.

Publicité

Table des Matières
loading

Table des Matières