Table des Matières
Publicité
Safety Information
6.
Press and keep pressure on second trigger (1).
7.
Press end keep pressure on principal trigger (2).
8.
Keep triggers pressure (1 & 2) till the end of the opera-
tion.
9.
Check operation status on reporting LEDs (5). Green
(Ok), Red (NOk).
Battery
Battery packs which have not been used for some time
should be recharged before use.
Temperatures in excess of 50°C (122°F) reduce the perfor-
mance of the battery pack. Avoid extended exposure to heat
or sunshine (risk of overheating).
The contacts of chargers and battery packs must be kept
clean.
For an optimum life-time, the battery packs have to be fully
charged, after used. To obtain the longest possible battery
life remove the battery pack from the charger once it is fully
charged.
The battery pack has overload protection that protects it from
being overloaded and helps to ensure long life. Under ex-
treme stress the battery electronics switch off the product au-
tomatically. To restart, switch the product off and then on
again. If the product does not start up again, the battery pack
may have discharged completely. In this case it must be
recharged in the battery charger.
Maintenance instructions
• Follow local country environmental regulations for
safe handling and disposal of all components.
• Maintenance and repair work must be carried out by
qualified personnel using only original spare parts. Con-
tact the manufacturer or your nearest authorised dealer
for advice on technical service or if you require spare
parts.
• Always ensure that the machine is disconnected from en-
ergy source to avoid accidental operation.
• Disassemble and inspect the tool every three 3 months if
the tool is used every day. Replace damaged or worn
parts.
• Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or de-
stroy plastic which could result in serious personal in-
jury.
• Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use.
Use clean clothes to remove dirt, dust, oil, grease, etc.
Disposal
• The disposal of this equipment must follow the legisla-
tion of the respective country.
• All damaged, badly worn or improperly functioning de-
vices MUST BE TAKEN OUT OF OPERATION.
12
Signs and Stickers
The product is fitted with signs and stickers containing im-
portant information about personal safety and product main-
tenance. The signs and stickers shall always be easy to read.
New signs and stickers can be ordered by using the spare
parts list.
Symbols
n
0
V
-1
min
Useful Information
Website
Information concerning our Products, Accessories, Spare
Parts and Published Matters can be found on the Chicago
Pneumatic website.
Please visit: www.cp.com.
Country of origin
HUNGARY
Copyright
© Copyright 2021, CHICAGO PNEUMATIC Tool Co.LLC,
1815 Clubhouse Road, Rock Hill, SC 29730 - USA
All rights reserved. Any unauthorized use or copying of the
contents or part thereof is prohibited. This applies in particu-
lar to trademarks, model denominations, part numbers and
drawings. Use only authorized parts. Any damage or mal-
function caused by the use of unauthorised parts is not cov-
ered by Warranty or Product Liability.
© Chicago Pneumatic - 6159925520
CORDLESS NUTRUNNER
Remove the battery pack before starting any
work on the machine.
Please read the instructions carefully before
starting the machine.
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the
end of their life must be collected separately
and returned to an environmentally compati-
ble recycling facility. Check with your local
authority or retailer for recycling advice and
collection point.
Always wear goggles when using the ma-
chine.
No load speed.
Volts
per minute
Direct Current
CAUTION! WARNING! DANGER!
Publicité
Table des Matières
