AIPTEK AN100 Mode D'emploi page 10

User's Manual
Troubleshooting
Symptom
The projector still can't be
turned on after 10
seconds of waiting.
The projected image is
blurred.
The temperature of the
projector's surface is
warm.
The projected image is
too dark.
Recovering from
abnormal
Check Point
Ensure the battery is fully
charged.
1. Adjust the focus. Please refer
to "Adjusting the Focus".
2. Check if the lens is dirty.
It is normal for this projector to
generate moderate heat during
operation.
1. Use the projector in a darker
environment.
2. Increase the brightness by
using the power adapter.
3. Scale down the projectional
image size.
If the projector is running
slow, freezing, crashing or
locking up during the
operation, you can try to insert
a slim, pointy object into the
reset hole to trigger a
hardware reset.
10