Honeywell RedLINK Guide D'installation page 7

Link remote control to wireless network (optional)
WIRELESS SETUP
Press to link
another EIM
YES
CONNECT MORE?
Link outdoor sensor to wireless network (optional)
Press and release
69-2091EFS_C.indd 7
Français : voir la page 21 • Español: vea la página 41
1 Make sure the Connected light on the
2 Press CONNECT at the remote. There will
CONNECT
3 When the screen displays "Connected,"
4 Press NO at the next screen to save and
M28481
Press to save
and exit
NO
M28482
1 Make sure the Connected light on the
2 Press and release the CONNECT button
3 Check thermostat to verify that the
(If you are installing more than one EIM,
repeat steps 1-3 for each.)
M28483
EIM is flashing (see page 5).
be a short delay as the remote seeks a
signal from the wireless network.
press DONE.
exit. (Or press YES and repeat steps 1-4
to link another EIM.)
If E1 appears, see error codes on page 14.
The linking procedure may time out if there is
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow, if
present) in the lower right corner of the screen
until the display changes (about 3 seconds).
EIM is flashing (see page 5).
on the back of the sensor.
outdoor sensor is working. After about
15 seconds, the thermostat should
display outdoor temperature and
humidity.
7 69-2091EFS—05
3/11/2009 12:52:50 PM