Storage; Storing - Efco MP 3000 Manuel D'utilisation Et D'entretien

STORAGE

Storing

If the machine is to be stored for long periods:
- Drain and clean the fuel and oil tank in a well-ventilated area.
- Dispose of fuel and oil according to the rules and respecting the
environment.
- To drain the tank, start the engine and wait until the fuel is
exhausted and the engine stops (leaving fuel mixture in the
carburettor could damage the membranes).
- Thoroughly clean the air filter (Fig. 38) and the cylinder fins
38
(Fig. 39).
- Store the water pump in a dry place, preferably not in direct
contact with the ground, away from heat sources and the tanks
empty.
- The procedures for returning the machine to service following
winter storage are the same as for starting up during everyday
use (page 10-14).
DEMOLITION AND DISPOSAL
When the machine has finished it's service life , due to service
exhaustion, wash it with the maximum attention as to remove
residual chemical products.
Most materials used for the machine manufacturing are recyclable;
39
metals (steel, aluminum, and brass) can be delivered to recycling
station.
For further information contact a recycling station service of your
area.
Machine disposal must be executed in respect to the environment,
avoiding soil, air and water pollution.
Local legislation enforced in matter should be respected in any
case.
en
19