Maintaining Your Appliance - Krups ESPRESSERIA AUTOMATIC PREMIUM Mode D'emploi

IFU display-GB hors tuv.qxd:Mise en page 1
EMPTYING THE COFFEE GROUNDS COLLECTOR, THE COFFEE CLEANING
The drip tray receives waste water and the coffee grounds collector receives used coffee grounds. The coffee cleaning tray
allows you to eliminate any deposits of coffee grounds above the percolation chamber.
If the above message
appears, remove, empty
and clean the drip tray.
As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow.
The warning message will remain displayed if the coffee grounds collector is not slotted in fully or not fitted correctly.
If the coffee grounds collector is fitted within less than 8 seconds, the appliance will ask you to confirm that you have
correctly emptied it. You cannot make espresso or coffee while the warning message is displayed.
The coffee grounds collector has a capacity of 9 coffees.
MACHINE CLEANING PROGRAM – TOTAL DURATION: ABOUT 20 MINUTES
You should perform the cleaning program about every 350 preparations of espresso or coffee.
The appliance will let you know when you need to proceed with cleaning through the 'clean' light coming on.
Caution! To benefit from the guarantee conditions, it is essential to perform the appliance cleaning cycle
when informed to do so. Be sure to follow the order of operations.
You can continue to use the appliance, but you are advised to perform the program as soon as possible.
To perform the cleaning program, you will need a container with minimum capacity of 0.6 litres and a KRUPS (XS 3000) cleaning
tablet.
If your machine is unplugged when cleaning or if there is a power cut, the cleaning programme will re-start at the
step in progress when the incident occurred. You will not be able to postpone this operation. This is essential
due to water system rinsing reasons. In this case, a new cleaning tablet may be required. Be sure to complete
the entire cleaning cycle to avoid any risk of irritation (seek medical advice if cleaning solutions are accidently
swallowed). The cleaning cycle is a continuous cycle and the pump can be heard intermittently. Do not put your
hands under the coffee outlets during the cycle.
Only use KRUPS (XS3000) cleaning tablets. We cannot be held responsible for any damage that may result
from the use of tablets from other brands.
You can obtain cleaning tablets from KRUPS Service Centres.
Make certain to protect your work surface during cleaning cycles, especially if they are made of
marble, stone or wood.

MAINTAINING YOUR APPLIANCE

TRAY AND THE DRIP TRAY
Remove, empty and Remove the coffee
clean the coffee cleaning tray.
grounds collector.
RINSING OUT THE CIRCUITS: SEE PAGE 5
Press the
key to start the
automatic cleaning
program when the
"Cleaning needed"
message is dis-
played.
27/01/09 9:08 Page 8
Clean it under water
and dry thoroughly
before re-fitting.
The automatic cleaning program is in
Just follow the
three parts – the cleaning cycle itself,
instructions
then 2 rinsing cycles. This program
shown on the
lasts about 20 minutes.
screen.
Press
any time and then choose MAINTE-
NANCE => OK => CLEANING from
the menus displayed.
8
The drip tray is equipped
with floats to tell you
when to empty it.
to perform cleaning at