Chapin MIXES 63950 Manuel D'utilisation Et D'entretien page 5

SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND HOLDER
The wand easily snaps into cap
handle or can be attached to the
pump handle using the wand clip.
3 STAGE FILTERING SYSTEM
This backpack sprayer is equipped with a 3 stage filtering system (see figure 1).
Stage 1 is a filter basket incorporated into the tank opening where fluid is added.
Stage 2 filter is located at the inlet of the pressure cylinder. Stage 2 is a removable
In-Tank filter. Stage 3 is a removable filter incorporated into the shut-off assembly.
Periodic cleaning of these filters is recommended to insure consistent fluid flow
through the sprayer. This will also reduce sprayer component wear.
The stage 3 filter is a removable filter incorporated into the inlet side of the shut-off
valve (see section "disassembling and repairing the shut-off valve"). Make sure
pressure is released before detaching the hose from the shut-off.
It is best to have no or minimal fluid in the pressure cylinder before removing and
reinstalling the stage 3 shut-off filter as fluid can leak from the hose.
Figure 2 Stage 2 (removable In-Tank filter)
Guide edge facing away from
pressure cylinder
FILLING SPRAYER TANK
Make sure the filter basket is in place to keep debris from entering the tank.
Fill sprayer tank with water.
FILLING CHEMICAL TANK
Push chemical tank up (figure 1), then pull out (figure 2).
Place chemical tank on a flat surface and fill with desired
amount of chemical.
Always follow the Chemical manufacturer's instructions.
Snap chemical tank back onto sprayer.
Guide edge on pressure
cylinder
Or
Figure 1
4E
Wand Clip
Figure 1
Stage 2
(Removable
In-Tank Filter
Stage 3
(removable
Shut-off filter)
Figure 2
Stage 1
(Filter
basket)
Pressure
Cylinder