Chapin MIXES 63950 Manuel D'utilisation Et D'entretien page 2

WARNING: Improper use or failure to follow instructions can result in explosive
failure causing serious eye or other injury. For safe use of this product you must read
and follow all instructions. Do not leave a pressurized sprayer in the hot sun. Heat can cause
pressure build-up resulting in possible explosion. Do not store or leave solution in tank after
use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protection when
spraying. Never use any tool to remove pump if there is pressure in the pressure chamber.
Never pressurize sprayer by any means other than the original pump. Do not attempt to
modify this sprayer. Replace parts only with manufacturer's original parts. Never spray
flammable, caustic, acidic, chlorine, bleach or other corrosive solutions or
heat, pressure, or gas producing chemicals. Always read and follow chemical
manufacturer's instructions before use with this sprayer as some chemicals
may be hazardous when used with this sprayer.
• PRE-USE CHECK: Before each use check tightness of hose nut to be sure hose is
securely attached to the shut-off assembly. Ensure hose is securely attached to the
tank by tightening hose clamp if necessary. Ensure that all nozzle and wand
connections are tight. Ensure the large pump clamp is tight. Ensure the 2 bolts
used to attach the pump lever to the pump shaft are tight.
• Do Not exceed a tank solution temperature of 120º F/ 49º C.
NOTE: The tank and hose may have residual water in it due to quality testing
performed on the sprayer.
WARNING
CAUTION
1E
SK 1158-1