Assembly And Adjustments - PowerSmith PLM14021H Manuel De L'opérateur

ASSEMBLY AND ADJUSTMENTS

Warning:
the parts are replaced. Using a product with damaged or missing parts could result in serious
personal injury.
Warning:
recommended for use with this product. any such alteration or modification is misuse and
could result in a hazardous condition leading to possible serious personal injury.
Warning:
you are ready to mow. Failure to comply could result in accidental starting and possible serious
personal injury.
Warning:
working. never operate the mower with damaged safety devices. Operating the mower with
missing or damaged parts can result in serious personal injury.
Warning:
always remove the battery pack from the product when assembling parts.
UNFOLDING AND ADJUSTING HANDLE ASSEMBLY
To Raise the Handle Assembly (FIG 2)
•
Pull and rotate the lower handle knobs 90° on both sides to loosen the lower handles.
•
Pull up the lower handles to the operating position. You may raise or lower the handle to a position comfortable for
you. There are 3 positions for you to choose.
•
Secure the lower handles by rotating the lower handle knobs 90° back to locking position.
NOTE:
ensure both sides are set at the same position for proper assembly.
•
Pull up the upper handle and raise it into its operating position. Make sure the lower handles are seated in the grooves
at the bottom of the upper handle.
•
Secure the upper handle by tightening the upper handle knobs (rotating clockwise).
NOTE:
Do not allow the starter cable to become pinched or trapped when raising the handle.
LOWER HANDLE
LOCKED POSITION
if any parts are damaged or missing, do not operate this product until
Do not attempt to modify this product or create accessories not
Do not insert safety key or battery pack until assembly is complete and
never operate the mower without the proper safety devices in place and
To prevent accidental starting that could cause serious personal injury,
3 POSITIONS
UPPER
HANDLE
UNLOCKED POSITION
English
LOWER HANDLE
KNOB
9
FIG 2