PowerSmith PLM14021H Manuel De L'opérateur page 11

ASSEMBLY AND ADJUSTMENTS
SETTING THE BLADE HEIGHT (FIG 6)
When shipped, the wheels on the mower are set to a low-cutting position. before using the mower for the first time,
raise the cutting position to the height best suited for your lawn. The mower can be set to 6 cutting heights between
2-3/8" (60 mm) and 4-1/8" (105 mm). Choose the proper cutting height according to the type and condition of the
grass.
Warning:
the motor, removing the battery pack and waiting for the blade to stop rotating.
Warning:
To Adjust the Blade Height (FIG 6)
•
Grasp the height-adjustment lever, and move it outwards.
•
Move the lever forward to lower the cutting height or backward to raise the cutting height, engage the lever in the
desired cutting-height position on the mower deck. Refer to fIG 6.
INSTALLING/REMOVING THE BATTERY PACK (FIG 7)
To Install the Battery Pack
•
lift and hold up the battery compartment cover.
•
align the battery pack with the mower's battery port.
•
Push the battery pack in and make sure it snaps in place and is fully seated and secured in the port.
NOTE:
The mower requires two Plb14025 battery packs installed to work.
To Remove the Battery Pack
•
lift and hold up the battery compartment cover.
•
Press and hold the battery release button of the battery pack.
•
Remove the battery pack from the battery port.
FIG 7
Do not make any adjustment to the lawn mower without first stopping
Keep your feet away from the deck when adjusting its height.
HEIGHT ADjUSTMENT
LEVER
English
SeTTING
1
2
3
4
5
FIG 6
6
FIG 8
11
CUTTING HeIGHT
2 3/8"
2 3/4"
3 1/8"
3 1/2"
3 3/4"
4 1/8"
KEY HOLDER
SAFETY KEY
KEY SLOT