Cleaning Pads; Suction Fan, Sensors, Rubber Blade, And Drive Tracks - NRG ENERGY RWC-1 Manuel D'instructions

EN
Maintenance
In order to ensure maximum safety, the device must be switched off and
disconnected from the mains during maintenance.

Cleaning Pads

Remove the microfibre cleaning pads from the robot and soak them in fresh
water. Thoroughly rub the cleaning pads, then rinse them and leave them
to dry.
The cleaning pads are also machine washable at 30 °C. Please do not use
fabric softener. Do not tumble dry the cleaning pads.
Let the cleaning pads dry before using them with the device again. Replace the
pads once they are significantly worn or dirty.

Suction Fan, Sensors, Rubber Blade, and Drive Tracks

Suction fan
Flip the robot and wipe down the suction fan with a dry cloth in order to remove
any residual dirt. This ensures that the suction power of the robot is maintained.
Edge sensors
Flip the device and wipe down the five edge sensors with a dry cloth in order to
remove any dirt.
Rubber blade
Wipe down the rubber blade with a dry cloth in order to maintain its proper
functioning.
13