Krups DEFINITIVE Série Instructions page 10

KR_COFFEEMAKER_KM740D50_NAFTA_V8_OK_Mise en page 1 12/07/12 08:44 Page12
English
PROBLEM
The brew basket (j)
overflows or the coffee
drips too slowly.
The coffee has a bad
taste.
You can not close the
top lid of the coffee
maker properly
Coffee drips on the heat-
ing plate, when removing
the carafe
On each use, the clock
starts at 0:00
You can not enter the de-
sired settings for auto-
matic programming
You can not pre select
the reduced temperature
of the warming plate for
automatic operation
The automatic function
did not start at the se-
lected time
The coffee does not drip
in the carafe
The coffee is too cold
If your appliance still does not work properly, please call your respective country's Consumer Service.
12
n Coffee maker needs cleaning.
n Excessive amount of coffee. We recommend that you use one measuring
spoon or one tablespoon of coffee ground per cup.
n Coffee grind is too fine (beans ground for an Espresso maker are not
suitable for drip coffee makers).
n Some coffee grounds have seeped in between the paper filter or
permanent filter and the filter holder (i).
n The paper filter is not open or is incorrectly positioned.
n Rinse out the filter holder (i) before putting in the paper filter so that its
edges stick to the damp sides of the filter.
n More than one paper filter in filter holder (i).
n The coffee dispenser needs to be cleaned.
n The coffee grounds are no suited to your coffee dispenser.
n The proportion of coffee to water is inadequate. Adjust it to suit your
taste.
n The quality and freshness of the coffee are not optimal.
n Poor-quality water. Use filtered or bottled water.
n Check to ensure the filter holder is inserted correctly
n The filter holder is too large : only use a paper filter of the suitable size
n Place the carafe back on the heating plate, the pause & serve
mechanism is blocked. Wait until the filter holder is completely empty.
Clean the filter holder
n Set the clock (section 4. Setting the clock) The setting of the clock will
be deleted when the appliance is unplugged or after a power failure.
n Set the clock (section 4. Setting the clock)
n The appliance is switched off during programming : you can only
program the temperature of the warming plate if the appliance is in
operation (red light on ON/OFF button and orange light on the keep
warm button)
n Adjust the clock. Pay attention to the AM and PM indicators
n Check the setting of the clock
n Check start time as well as AM and PM indicators
n Check to make sure the water tank is filled
n The appliance is switched off
n Press the keep warm
(the heating plate temperature is reduced and the orange light of the
keep warm button will blink.
SOLUTION
button to switch back to normal temperature