Wall Mounting The Center Speaker; Before Mounting; Additional Notes On Speaker - Pioneer DCS-202K Mode D'emploi

Wall mounting the center
speaker
The center speaker have a mounting hole
which can be used to mount the speaker on
the wall.

Before mounting

Remember that the speaker system is heavy
and that its weight could cause the screws
to work loose, or the wall material to fail to
support it, resulting in the speaker falling. Make
sure that the wall you intend to mount the
speakers on is strong enough to support them.
Do not mount on plywood or soft surface
walls.
Mounting screws are not supplied. Use screws
suitable for the wall material and support the
weight of the speaker.
CAUTION
• If you are unsure of the qualities and strength of
the wall, consult a professional for advice.
• Pioneer is not responsible for any accidents or
damage that result from improper installation.

Additional notes on speaker

Install the main front left and right speakers at
an equal distance from the TV.
Precautions:
Make sure that all the bare speaker wire is
twisted together and inserted fully into the
speaker terminal. If any of the bare speaker
wire touches the back panel it may cause the
power to cut of as a safety measure.
The front, center and surround speakers
supplied with this system are magnetically
shielded. However, depending on the
installation location, color distortion may occur
if the speaker is installed extremely close to the
screen of a television set. If this case happens,
turn the power switch of the television set
OFF, and turn it ON after 15 min. to 30 min. If
the problem persists, place the speaker system
away from the television set.
The subwoofer is not magnetically shielded
and so should not be placed near a TV or
monitor. Magnetic storage media (such as
loppy discs and tape or video cassettes)
should also not be kept close to the subwoofer.
Do not attach the front/surround speakers and
subwoofer to a wall or ceiling. They may fall of
and cause injury.
Installation 19
3