Adjusting The Microphone Angle; Appendix; Troubleshooting - Pioneer AVH-270BT Mode D'emploi

Installation
2
1 Double-sided tape
2 Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
3 Keeping it away from the steering wheel.
Adjusting the microphone
angle
36

Appendix

Troubleshooting

If you have problems operating this product, refer to this sec-
1 tion. The most common problems are listed below, along with
likely causes and solutions. If a solution to your problem cannot
be found here, contact your dealer or the nearest authorized
Pioneer service facility.
Problems with the AV screen
CD or DVD playback is not possible.
 The disc is inserted upside down.
— Insert the disc with the label upward.
 The disc is dirty.
— Clean the disc.
 The disc is cracked or otherwise damaged.
— Insert a normal, round disc.
 The files on the disc are in an irregular file format.
— Check the file format.
 The disc format cannot be played back.
— Replace the disc.
 The loaded disc is a type this product cannot play.
— Check what type of disc it is.
The screen is covered by a caution message and the video
cannot be shown.
 The parking brake lead is not connected or applied.
— Connect the parking brake lead correctly, and apply the
parking brake.
 The parking brake interlock is activated.
— Park your vehicle in a safe place and apply the parking
brake.
The audio or video skips.
 This product is not firmly secured.
— Secure this product firmly.
No sounds are produced. The volume level will not rise.
 Cables are not connected correctly.
— Connect the cables correctly.
 The system is performing still, slow motion, or frame-by-
frame playback with DVD-Video.
— There is no sound during still, slow motion, or frame-by-
frame playback with DVD-Video.
 The system is paused or performing, fast reverse or forward
during the disc playback.
— For the media other than music CD (CD-DA), there is no
sound on fast reverse or forward.
The icon  is displayed, and operation is impossible.
 The operation is not compatible with the video configuration.
— This operation is not possible. (For example, the DVD
playing does not feature that angle, audio system, subtitle
language, etc.)
The picture stops (pauses) and this product cannot be
operated.
 The reading of data is impossible during disc playback.
— Stop playback once, then restart.
The picture is stretched, with an incorrect aspect ratio.
 The aspect setting is incorrect for the display.
— Select the appropriate setting for that image.
A parental lock message is displayed and DVD playback
is not possible.
 The parental lock is on.
— Turn the parental lock off or change the level.
The parental lock for DVD playback cannot be canceled.
 The code number is incorrect.
— Input the correct code number.
Playback is not with the audio language and subtitle
language settings selected in "DVD/DivX Setup".
 The DVD playing does not feature dialog or subtitles in the
language selected in "DVD/DivX Setup".
— Switching to a selected language is not possible if the
language selected in "DVD/DivX Setup" is not recorded
on the disc.
The picture is extremely unclear/distorted and dark during
playback.
 The disc features a signal to prohibit copying. (Some discs
may have this.)
— Since this product is compatible with the copy guard
analog copy protect system, the picture may suffer from
horizontal stripes or other imperfections when a disc with
that kind of protection signal is viewed on some displays.
This is not a malfunction.