Programming - golmar 2PLUS Manuel D'installation

TELEPHONES PROGRAMMING
P
rogramming the telephones.
Set to ON the configuration dip switch number 2 (as shown in page
58). It is found at the rear of the sound module.
The door panel emits a sound announcing that it has come into the
programming mode.
In systems with more than one door panel, proceed equally but only
on the main door panel of each building.
Every apartment must have one master unit only; in case of parallel units configure
them as slave.
Press the door release push button, and while pressing
it, pick the handset up.
To show that the system is ready for programming, the
door panel and the handset will emit some tones. At
this moment it is possible to establish audio commu-.
nication. Release the door release push button.
To programme the telephone as the main telephone
To programme it as slave telephone, press the door
Make a call to check the telephone has been successfully programmed.
Proceed equally with the rest of telephones.
Once programming has been finished, set to OFF the programming
switch. If you don't, the door panel will emit a sound to advise that
the system is still into the programming mode.
Press the door panel push button that will
call to this telephone.
At this moment, the door panel and
the handset will emit a sound.
hang the handset up.
release push button and then hang the handset up.
63