Titan TITANARG -SHARP Notice D'instructions page 18

For changing the tensioning sleeve the same procedure has to be followed, yet in this case the
tensioning nut has to be removed completely to make this possible.
The procedures are explained hereunder and shown on a sketch.
Pull plug from socket before working on the tool!
The diameters of clamping ring and grinding wheel carrier have to be identical, otherwise the
clamping ring will be destroyed.
Insert grinding wheel carrier into clamping ring.
The wheel carrier has to sit on the tensioning nut
Very important!!!
Put wrench SW17 to spindle and tighten tensioning nut using wrench SW17.
Put grinding wheel on grinding wheel carrier. Warning: press fit, don't cock. Put lock washer, bolt
on tensioning nut and tighten using wrench SW 10.
TITAN-Sharp 18
H707 EU 38/06