Switching On/Off; Change Of Grinding Wheel; Change Of Grinding Wheel Carrier - Titan TITANARG -SHARP Notice D'instructions

3 Switching ON-/OFF:
Switching on:
Push slide switch back and
press down front part for lock-
up
Power line connection:
Connect to single phase AC line only and to the voltage shown on the plate. Can also be
plugged to sockets without protection earthing, as there is protection insulation as per DIN 57
740/VDE 0740 resp.. CEE 20. Radio non-interferency corresponding to EN 55014.
5
Pull plug from socket before working on the tool!

Loosen stud bolts on the side

Remove head

Loosen and remove tensioning nut. WARNING: Left-hand thread!

Remove lock washer

Exchange grinding wheel

Warning: press fit!

Put lock washer

Bolt on tensioning nut and tighten

Change of grinding wheel carrier

Pull plug from socket before working on the tool!

Put wrench SW17 to spindle

Put wrench SW17 on tensioning nut

Loosen tensioning nut

Exchange grinding wheel carrier

Tighten tensioning nut
TITAN-Sharp

Change of grinding wheel

Switching off:
Press down rear part of slide switch.
The switch will automatically return to its 0-
position
H707 EU 38/06
17