Blatchford LINX22L1S Manuel page 24

Flow Diagram A—Button-Programming Mode for Calibration/Adjustment
Power On
Press
[ + ] [ - ]
+
Press
[ + ] [ - ]
Enter Button-Programming mode
for Calibration/Adjustment
Prepare to Enter
Yield Adjust
1
1
[ + ]
[ - ]
2
Prepare to Enter
Stance Release
1
Moves to next
[ - ]
stage automatically
2
Prepare to Enter
Walk Calibration
1
Moves to next
[ - ]
stage automatically
2
Prepare to Enter
Foot Calibration
Moves to next
1
[ - ]
stage automatically
2
Calibration Complete
LED Power-ON
Sequence
2
Audible
Response
2
2
Get user ready
to adjust yield
for sitting
Calibration
With user standing, supported, adjust yield up/
complete
down as required: Flex knee ~15° then fully extend
to decrease yield by 1 step. Flex knee ~40° then fully
extend to increase yield by 1 step.
Get user ready
to walk in a
straight line
Auto-calibration complete
Get user ready
to walk in a
straight line
Auto-calibration complete
Get user ready
to walk in a
straight line
Auto-calibration complete
or
1
[ - ]
[ - ]
1
[ + ]
1
[ + ]
User walks in straight line at medium speed on
level ground until next audible alert sounds to
indicate auto-calibration complete (~4-5 steps).
1
[ + ]
User walks in straight line at medium speed on
level ground until next audible alert sounds to
indicate auto-calibration complete (~6 steps).
1
[ + ]
User walks in straight line at medium speed on
level ground until next audible alert sounds to
indicate auto-calibration complete (~10 steps).
1
[ + ]
[ - ]
24
Press [-] to move back one
"Prepare to Enter " stage.
Press and hold [-] at any
time to exit program. (LED
extinguishes).
5
Yield Adjust
mode
4
Stance Release
Calibration mode
3
Walk Calibration
mode
6
Foot Calibration
mode
2
No activity time-out
Exit Button-
Programming mode
938353V2APK1/1-0321
1 step
1
down =
1 step
2
up =
[ - ]