Installation Room Unit Hcw 80 - Honeywell HC60NG Manuel D'installation Et Utilisation

Installation
3.2.

Installation room unit HCW 80

WARNING Insufficient data transfer!
Interference of the radio receiver in the
device due to metallic objects or further
radio devices.
Ensure there is sufficient distance to
►
metallic objects.
Mount the device with a distance of at
►
least 1 m to radio devices such as
radio headphones, cordless phones
according to the DECT standard, etc.
Select another installation site if the
►
radio interference cannot be
corrected.
Fig. 10: Positioning the room unit HCW 80
Place the room unit HCW 80 at the installation site.
►
Remove the housing cover of the room unit HCW 80
►
(see Fig. 11: Removing the housing cover).
2
1
Fig. 11: Removing the housing cover
Mark the drill holes according to the drilling template
►
(see Fig. 12).
8
Fig. 12: Drilling scheme (measurements in mm)
Drill the holes.
►
Screw on the room unit.
►
Insert the supplied AA batteries with the correct battery
►
polarity (see Fig. 13: Battery polarity and send button).
Fig. 13: Battery polarity and send button
The batteries have to be replaced when the red
LED at the room unit HCW 80 flashes (see
section 9 "Changing batteries").
Place the housing cover in
►
position above and snap it down
(see Fig. 14).
Red LED
Send button
Fig. 14: Placing housing
cover in position