Available Accessories - DEFA MultiCharger Mode D'emploi

DEFA MultiCharger/MarineCharger/RescueCharger 1x20A and 2x20A are based on modern switch-mode technology
and galvanized divisions. These chargers represent the latest technology within battery charging and will give the
batteries optimum life.
It is well suited to battery sizes up to approx. 300Ah and can maintenance charge the battery for an unlimited time.
The charger can stand parallel charging up to 17A parallel consumption at the same time as it charges the batteries.
The charging voltage is temperature compensated with external sensor.
DEFA MultiCharger/MarineCharger/RescueCharger 2x20A has two separate charge outputs and each output has a
separate temperature sensor and remote LED.
To satisfy customers with different needs the charger comes without a fixed charging cable. This has to be obtained
separately and there are several different lengths available, as well as remote LED panel. See accessories list below.
Item number
705294
705295
705296
705164
705165
See Picture on page 4. The Picture shows the charge process in a graph with Voltage (V) and Current (I) over time (t)
The LED on the front of the charger shows the charger status:
Green pulse – Charging
Solid green – Fully charged
Red pulse – Error
Read the user manual carefully. Wrong installation can result in damage to the equipment and possible injury. If there
are any uncertainties, please contact DEFA or a qualified person. Fix the charger properly where it is to be installed.
See drill guide on page 4. Connect the charger according to the diagram on page 5. Connect red wire to (+) end black
wire to (-) The charger is intended for use with lead/acid, AGM and GEL batteries, but the battery manufacturers
recommendations should always be taken into consideration. The charger has to be installed with the connectors
facing downwards to maintain IP rating 44.
NOTE: To make sure the correct charging voltages the charging cables must not we shortened or made longer
NOTE: Route the cables onto the contacts on the battery charger (Page 3, picture 1) so that they are straight, in order
to prevent the PlugIn contacts from being bent or twisted (Page 3, picture 2).
6
ABOUT THE CHARGER

AVAILABLE ACCESSORIES

Name
5m Remote LED Panel, 1 channel
10m Remote LED Panel, 1 channel
20m Remote LED Panel, 1 channel
20m Remote LED Panel, 2 channel
25m Remote LED Panel, 2 channel
CHARGE PROCESS
INSTALLATION
Item number
706483 2m Charge cable
706484 4m Charge cable
706485 6m Charge cable
Name