Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If the device's external input signal is too low, it will automatically go to standby
mode after approx. 20 minutes. Please increase the input signal of your externally
connected device.
MODE selection
Press the [INPUT] button
on the device or press the [INPUT] button
on the
3
2
remote control to select the desired input mode, which will be shown on the device's
LED indicator
:
5
• RED: standby mode.
• RED - FLASH: USB
• RED SLOWLY FLASH: AUX mode.
• BLUE/RED FLASH: HDMI ARC mode.
• PURPLE: optical mode.
• BLUE QUICKLY FLASH: BT pairing mode
• BLUE: BT mode (connected).
Please note:
If the device source is in BT mode, and the BT connection is no longer active or out
of range, the LED indicator
will flash blue.
5
Volume control
• Press the volume + & - buttons
&
on the device, or the [VOL+] & [VOL-]
1
2
buttons
on the device's remote control to adjust the volume.
4
• If you wish to turn the sound OFF, press the [MUTE] button
on the remote
3
control. Press the [MUTE] button
again or press the [VOL+] & [VOL-] button
3
4
to resume normal volume.
Selecting a pre-set sound effect
While playing, press the [EQ] button
on the device's remote control to select the
10
desired pre-set equalisers.
4) SPECIFICATIONS
• Power input: 15Vdc – 1,6A
• Power consumption: 30W (1.8W in standby mode of the device, <0.5W if
disconnected from device)
• Stereo speakers: 30W (2x 15W)
• Speaker resistance: 8 Ω
• Frequency response: 80 Hz – 20 kHz
• BT version 4.2
• Transmission power: Class II
• Operation distance: up to 10 m
• Frequency: 2.4 Ghz. – 2.48 Ghz
• BT profiles: A2DP, AVRCP, HFP, HSP
• Remote control distance: 56m, angle 30°
EN 10
Publicité
Table des Matières
