Welding - Nupi EloFit 00E8500L Manuel D'emploi

Welding

In the next screen display, you will be prompted to enter the welding details contained in
the fitting bar code can be entered, by using the keys
confirm.
After completing data entry, the display unit will show the following screen:
Type of
Fitting
Fitting
rated
diameter in mm
and in inches
Weld voltage
in Volt
After checking the entered data once again, press either ENTER
ESCAPE to delete the action and return to the previous screen display.
If the fitting connection has not been carried out yet, you will be prompted to carry out
fitting connection in the next screen display.
After connecting the fitting press ENTER
The next screen shows a message reminding the operator that, before welding, all the
required preparatory actions must have been completed (scraping and cleaning).
You will also be reminded that, in order to ensure good welding, an alignment clamps
must be used. Press ENTER
screen display.
A summary of the information entered so far will be displayed at this point as shown here
below:
Rated diameter of fitting
to weld
Welding time in
seconds
Welding voltage
in Volts
Fitting symbol
Type= I (COUPLER)
Diam. =
U welding =
t welding =
Rated welding time
in seconds
to continue.
to continue or ESCAPE
D = ________
Time = ________
Voltage = ________
ENT= Proceed ESC= Back
6
and then ENTER
Fitting
descript.
to confirm or
to return to the previous
to
Connect fitting
Connect fitting
Ftng = _________
ENT
Press
Scraping/Cleaning ?
Y
ENT No
Using pipe aligner ?
Y ENT No
ESC
ESC