Technical Specifications; Working Conditions; Input - Nupi EloFit 00E8500L Manuel D'emploi

Technical specifications

Polyvalent welding unit
Weight
Dimensions
Max power absorption

Input

Working temperature
Application range
Power cable
Welding cables
Screen
IP protection class
Max welding voltage

Working conditions

Input
The 00E8500L welding unit input should be exclusively:

230 V 50 Hz quality alternating current (maximum tolerance 20%);
We therefore recommend to ensure that the power source that you intend to use is up to
the required characteristics. If input to your polyvalent welding unit is from a voltage
generator, make sure that it is of the asynchronous type. Before purchasing a generator,
contact our Customer Service Representative to obtain more information on its required
characteristics.
If extension cables have to be used, pay special attention to the cable cross section to
length ratio, to prevent affecting your polyvalent welding unit smooth operation; in
particular, as far as extension table cross sections are concerned, the following chart
applies:
Cable Section
2.5 mm
4.0 mm
6.0 mm
WARNING: it is always advisable to use fully unwound extension cables.
230/115V 15,6 kg (35 lb)
310 x 350 x 160 mm (11" x 12" x 6" )
1000 VA
230/115V 50Hz / 60Hz
-18 °C to + 52 °C (0 °F to 125 °F)
20÷160 mm (1/2"÷6")
Length 4 m (13 ft)
Length 4 m (13 ft)
Backlit LCD, 4 lines, 20 columns
54
42V
Recommended length
2 6 - 7 m (19.69 – 22.97 ft)
9 - 11 m (29.53 – 36.09 ft)
2
15 - 17 m (49.21 – 55.77 ft)
2
3