Entering General Information; Preliminary Note; Language Setting - Nupi EloFit 00E8500L Manuel D'emploi

Entering general information

PRELIMINARY NOTE: if, on powering on the processor, the display reads MAINTAIN
After powering on your welding unit via the main switch, the machine display unit will
look as is shown opposite:
welcome message
Welcome
(UK) machine dialogue language
S.R: . Software version or revision
Mainten. in it indicates the number of days to the next welding unit service /
resetting.
Without pressing any key, wait for the screen to automatically go to the next screen
display after a few seconds; this screen page shows the serial number of the machine in
use.
To return to the previous screen display, press the key ESCAPE
If no key is pressed by the operator, after a few seconds the machine will once again
automatically go to the next screen display, showing the current time and date. To
modify either value, press the key
required values. After setting the right values, hit the ENTER
to the previous screen display, press the key ESCAPE

Language setting

To set your working language, power on the welding unit, and wait for the screen display
opposite to be shown (where I, Italian, refers to the pre-set working language). Now
press the ARROW UP
the key ENTER .
ACC. TO UNI 10566, please contact our Customer Service
Representative staff to organise maintenance.
, and then, press either
key to select your required language and confirm by pressing
5
.
or , to enter your
key to confirm. To return
.
Welcome (UK)
S.R. ___ _
Mainten. in_____
Serial Number
__________________
Time Date
_______ _______
Welcome (I)
S.R. ___
Mainten. in 000 days