EGO LB5300 Guide D'utilisation page 28

Trimmer head will
not advance line.
Grass wraps around
trimmer head and
motor housing.
Line is not cutting
well.
28
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER
◾ ◾
The motor shaft or trimmer
head is bound with grass.
◾ ◾
Not enough line on spool.
◾ ◾
Trimmer head is dirty.
◾ ◾
Line is tangled on spool.
◾ ◾
Line is worn too short.
◾ ◾
Cutting tall grass at ground
level.
◾ ◾
The line-cutting blade on
the edge of the guard has
become dull.
◾ ◾
Stop the trimmer, remove the
battery, and clean the motor shaft
and trimmer head.
◾ ◾
Remove the battery and replace the
cutting line; follow the section "LINE
REPLACEMENT" in this manual.
◾ ◾
Remove the battery and clean the
spool, spool retainer and spool base.
◾ ◾
Remove the battery, remove the line
from the spool and rewind; follow
the section "LINE REPLACEMENT" in
this manual.
◾ ◾
Remove the battery and pull the
lines while alternately pressing down
on and releasing the bump knob.
◾ ◾
Cut tall grass from the top down,
removing no more than 8 inches in
each pass to prevent wrapping.
◾ ◾
Sharpen the line-cutting blade with a
file or replace it with a new blade.