EGO LB5300 Guide D'utilisation page 24

10. With the spool base facing
downward, align the slots in the
spool retainer with the tabs on the
spool base and press the retainer
evenly down until it snaps into place
(Fig. 21).
NOTICE: Make sure the tabs on the spool
base snap into place or the spool will
come out during operation.
Install a pre-wound spool
WARNING:
tool before servicing, cleaning, changing attachments or removing material from the
unit.
1. Press the release tabs on the spool base and remove the retainer by pulling it
straight out (Fig. 15).
2. Remove the spool. Use a clean cloth to clean the inner surface of the spool
retainer and spool base.
3. Check the spool retainer, spool and spool base for wear. If necessary, replace the
wear parts.
4. Place a pre-wound spool on the spool retainer.
5. Align the notches of the spool from which the lines protrude with the eyelets in
the spool retainer and position the spool in the retainer (Fig. 19).
6. Hold the spool and spool retainer; grasp the line and pull it to release the line
from the notch in the eyelet (Fig. 20).
7. With the spool base facing downward, align the slots in the spool retainer with
the tabs on the spool base and press the retainer evenly down until it snaps into
place (Fig. 21).
NOTICE: Make sure that the tabs on the spool base snap into place or the spool will
come out during operation.
24
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER
To prevent serious personal injury, remove the battery pack from the
21
Slot
Tab