Cognex In-Sight Micro Série Manuel page 7

Connect the Inputs and Outputs (Optional)
The vision system's I/O connector supplies connections for the acquisition trigger and
high-speed outputs.
CAUTION: All cable connectors are "keyed" to fit the connectors on the vision
system; do not force the connections or damage may occur.
Option 1: Connect the Breakout Cable
Note: Unused bare wires can be clipped short or tied back using a tie made of
non-conductive material.
1. Connect the Breakout cable's M8 connector to the vision system's I/O
connector.
2. Connect the trigger and high-speed I/O wires to an appropriate device (for
example, a PLC, trigger sensor or strobe light).
Option 2: Connect the I/O Module Cable
Note: Refer to the In-Sight
discrete input and output lines.
1. Connect the I/O Module cable's M8 connector to the vision system's I/O
connector.
2. Plug the I/O Module cable's DB15 connector into the I/O module's I/O
connector.
®
Explorer Help file for details on configuring the
6