Bosch HEZCMT3050 Instructions D'installation page 6

4. Measure 1½'' (38 mm) from top edge of warming
drawer and make mark on both sides of cabinet.
1½" (38) 1½" (38) 1½" (38)
5. Install the Left and Right Side Cabinet Brackets flush
to the cabinet face with two (2) ¾'' Phillips head wood
screws per side. Install side trim mounting bracket so
that the bottom edge of the bracket is aligned with
the pencil mark.
1
dia. 1/16"
6. Secure the Left Side Mounting Bracket to the Left
Side Warming Drawer Clearance Bracket using three
½
(3) x '' T-20 Torx head screws.
Page. 5
7. Secure the two (2) Warming Drawer Clearance
Brackets to the top of the installed warming drawer
using the outer holes with six (6) ½'' T-20 Torx head
screws.
8. Secure the Left Side Mounting Bracket to the Left
Cabinet Mounting Bracket using one (1) ½'' T-20 Torx
screw.
9. Secure the two (2) Transformer Support Brackets to
the Warming Drawer Clearance Brackets with four
(4) ½'' T-20 Torx head screws.