Dremel 7300-PGT Consignes De Fonctionnement/Sécurité page 16

2610046266_7300-PGT 3/21/17 10:17 AM Page 16
shaft 8 and twisting the collet nut 3 clockwise over the
collet to tighten it back onto the output shaft 8 (Fig. 5).
To load sanding disc:
1. Pull spring-loaded sleeve 9 DOWN towards tool
with one hand and hold. You can brace the tool on
the body or workbench for extra leverage (Fig. 3).
2. With the other hand, align bow tie interface 10 on
mandrel with metal bow tie interface 11 on bottom
of sanding disc 12 (Fig. 3).
3. Place sanding disc on the mandrel to a point just
below the bow tie on the mandrel 10 and twist 90
degrees until the bow tie interface 11 on the sand-
ing disc 12 aligns with the sleeve 9. Release sleeve
9. Sanding disc 12 should lock in place (Fig. 4).
FIG. 6
2
7
To attach nail guard attachment:
Note: Make sure that the mandrel and the sanding
disc are mounted properly before mounting the
attachment.
A. Detach the clear cap 2 from the attachment by
running the small knobs 6 on the inside of the
clear cap up along the height adjustment guide 7
until they reach the guided opening (Fig. 6).
B. Unlock the clasp 3.
C. Open the attachment 1 (Fig. 6).
D. Position the attachment 1 around the threaded
16
personal injury or property damage. To check for
proper seating, hold shaft lock button 2 and twist the
sanding disc 12. The sanding disc 12 will not be able
to rotate on mandrel.
1. Pull spring-loaded sleeve 9 DOWN toward tool
with one hand (Fig. 4).
2. Hold sleeve 9 down while twisting sanding disc 12
90 degrees (Fig. 4).
3. Remove sanding disc 12 (Fig. 4).
FIG. 7
A
1
6
B
3
1
C
nose of the tool 8 and close the attachment
together until the clasp 3 is fully engaged (Fig. 7).
E. Turn the whole attachment 1 clockwise to screw it
into place on the threaded nose 8. Make sure that
it is securely tightened so that it will not shift posi-
tions during use (Fig. 7).
F. Re-attach the clear cap 2 (simply perform step A
in reverse order).
G. Turn the clear cap so that the small knobs are all
the way to the end of slot 7 (next to number "3")
on the attachment. You will hear the cap click into
Incorrect seating of sanding
disc on mandrel may lead to
To unload sanding disc:
D
E
3
8