Panasonic CS-VZ9SKE Mode D'emploi page 11

To enjoy quiet operation
QUIET
• This operation reduces airflow noise.
ODOR
To release odor from indoor unit
CLEANUP
• This operation release odor from the internal indoor unit.
• Press ODOR CLEANUP for 3 seconds or more. The
operation activates for 20 minutes, and resume to the
presetting operation automatically.
• OFF timer: ODOR CLEANUP continuous display and the
operation stopped after odor removal end.
• SLEEP timer: ODOR CLEANUP immediately stop and OFF
"ODOR CLEANUP" display.
• Get fresh air from outside by opening the windows or door.
To enjoy warm (hot) air from start
PRE
HEATING
heating
• This operation to blow warm (hot) air as soon pressed the
HEAT button.
• When start PRE HEATING operation, the air conditioner
could not blow immediately because it is not warm enough
to blow.
• When it is in PRE HEATING operation, the power lamp will
not light up.
• Before start operation, please make sure that the current
time is correct.
• <Operation schematic: example>
5:30 6:00
6:00 ~ 7:00 The learned time zone by the most frequent
"ON" heating
5:30 ~ 8:00 PRE HEATING standing by time zone
• Display on the remote control.
• Condition of PRE HEATING operation.
The room temperature should be less than 18°C and the
outdoor temperature should be less than 10°C and previous
operation is heating.
• Recommending OFF this function when heating is not
operated for a long time.
To create sleeping comfort
SLEEP
0.5 1 2 3 5
SLEEP
• This operation provides you with a comfortable environment
while sleeping by gradually decrease and/or increase the
set temperature within 1°C for avoiding the room from
unnecessary cooling and/or heating.
• Can be set together with single timer or twin timer.
• When used together with the daily timer, sleep operation has
a priority.
7:00 8:00
7 9hr Cancel
See "To learn more..." for details.
To change setting according to
MENU
living environment
• 5 options are available in MENU.
Pressing MENU button at each time, display shows
options below.
CENTER AUTO OFF
BACK LIGHT CONTRAST 3
1 Select preference options.
1. Indoor unit installation location
CENTER LEFT
2. Auto OFF operation
AUTO OFF AUTO OFF
OFF ON
* Stops operation combined with AUTO COMFORT
function after human sensor not detecting for 3
hours or more.
3. Indoor unit indicator brightness
BRIGHTER DIMMER
LED LED
4. Remote control LCD contrast
CONTRAST 4 5
3
5. Brightness of the back light of the remote control
BACK LIGHT BACK LIGHT
STANDARD DIM
2 Pressing either buttons to select preference setting.
3 Press SET to confirm the setting.
SET
Each options confirmed by the repeating of process from
1 through 3 above.
BRIGHTER LED
RIGHT
ECONAVI
OFF
6 7 1 2
BACK LIGHT BACK LIGHT
OFF BRIGHT
11