Daewoo DMF-4002S Mode D'emploi page 5

 Remove the Fan Blade Nut (2) and the Rear Grille Lock Nut (4) from the Motor Shaft Spindle
(n).
 Fit the Rear Grille (5) by positioning it onto the location pins (p). Secure the grille (5) to the
Motor Body with the Grille Lock Nut (4). Note: The handle on the Rear Grille(5) must face
upward.
 Push the Fan Blade (3) onto the Motor Shaft Spindhe (n) by matching the Slots on the Base
of the Fan Blade with the Shape Pin (o).
 Secure the Blade (3) with the fan Blade Nut (2) by turning it COUNTER - CLOCKWISE.
Check that the fan blade rotates freely by turning it with your hand.
 Open securing clips around the front grille and loosen the clip screw at the top of the front
grille. Position the top clip on the uppermost part of the rear grille. Push the top clip down
and press rim of the front grille onto the rear grille. Close all the clips and tighten the safety
screw.
 Place the Water Tank on the Humidifier Power Base.
 Connect the Mist Delivery Hose to the Mist Outlet and the Cap of Water Tank.
 Place the Cap of Water Tank on the Water Tank.
 Insert 2 x AAA size batteries (not supplied) into the remote control.
 The 40cm Pedestal Mist Fan is now ready to use.
OPERATING THE MIST FAN
 Remove the Water Tank from the Humidifier Power Base, turn it up-side down and you will
see a small plastic cover.
 Open the cover by turning it in a counter-clockwise direction.