Before A Hydromassage; Cleaning Cycle - GALA EMMA Manuel De L'utilisateur

User's manual Manuel de l´utilisateur
Manual de usuario
This bath is not intended for use by children or people with physical, sensory or mental impairment or who
16
lack the necessary experience or knowledge, unless supervised or instructed in the use of the equipment
by a person responsible for their safety.
Children must only use the bath under supervision, to avoid possible misuse.
Your bathtub has a security system that disconnects hidromasaje past 20 min. from its beginning; in case
you wish to continue with the hidromasaje bath, you can initiate it again, enjoying other 20 that min. of
hidromasaje.
7. OPERATION

7.1. BEFORE A HYDROMASSAGE

• In order for the bath water to circulate through the hydromassage circuit, ensure that the uppermost jets
are covered with water.
• Special hydromassage essences or soaps must be used. Otherwise a great quantity of foam may be
generated.
7.2. PROCESS
• Fill the bathtub with water until the uppermost jet is covered. Select the water temperature according to
your preference and the type of hydromassage bathtub to be taken.
• Get into the water and press the start button, (Fig.1. Water hydromassage), (Fig.2. Air hydromassage),
(Fig.3. Pulsating Hydromassage).
• The proportion of air, together with the water temperature, the duration of the bathtub and the use of oils,
essences or salts, will determine the effect of the hydromassage.
In general, it is recommended that the water stream should not be pointed directly at the body at an angle,
in order to obtain the greatest benefits of the massage.

7.3. CLEANING CYCLE

• After a hydromassage bath it is recommended to perform a cleaning cycle of the bathtub, especially
when it is foreseen that the bathtub will not be used for some time. The aim of the cleaning cycle is to
disinfect the bath and all the hydromassage circuit.
• When you have finished the bath and once you are out of the bathtub:
1) Pour into the water a measure of disinfecting cleaning liquid, in accordance with the cleaning liquid
manufacturer's instructions and the bathtub size.
2) Set the hydromassage in operation for 2 minutes.
3) Finally turn off the hydromassage and leave the disinfectant liquid to do its job for 20 minutes.
4) Empty the bathtub.