ELVA Rapid 55 C Mode D'emploi page 11

4 Adjust the machine
The machine can be adjusted to different bottle sizes as follows.
The bottle plate of the corker has to be adjusted so
that the bottle is slightly pressed into the
compressor once placed on the bottle plate.
The bottle has to remain in position without the
operators support.
Adjust the height of the wire-capper so that the
lower end of the wire-hood is pushed in the right
position. The lower wire has to be positioned right
below the outer bulge of the bottle neck.
ELVAmac SA
tél. +41 21 801 21 77
Route de Préverenges 10
fax +41 21 803 00 96
1026 Denges ; Switzerland
e-mail info@elvamac.ch www.elvamac.ch
page 11