Door Handle Installation - Summit Accucold FF6BI Série Mode D'emploi

For models FF6BI, FF6LBI, FF7LBI, FF7LBLBI, SCR600LBI and SCR600BLBI
NOTES: See illustration below.
All of the parts that are removed must be kept for the reinstallation of the door.
1. Unscrew the lower hinge and take off the door.
2. Push the kick plate to the right in the new position.
3. Undo the upper hinge fastener and fix it to the opposite side of the housing, where you
have already removed and replaced the fastener with the hole to the opposite side.
4. Put the door on the upper hinge fastener.
5. Fix the lower hinge in the new position.
6. Unscrew the handle and place it on the opposite side.
7. Some screws are covered with caps. Take off these caps before undoing the screws.
8. Check the door gasket. It should not be creased and should seal well.

Door Handle Installation

The door has two screw holes on each side, allowing you to install a handle (included). To
do so, align the handle with the screw holes on the side you prefer. Fix the handle in place
with the included screws, then cover the screw heads with the handle seal (included).
1. Upper hinge fastener
2. Lower hinge
3. Kick plate
:
4. Handle
5. Door hinge fixture
6. Door hinge fixture plug
8
:
Models FF6BI, FF6LBI,
FF7LBI, FF7LBLBI,
SCR600LBI and
SCR600BLBI