Using For The First Time - BOMANN TSG 7402.1 Mode D'emploi

Manual filling of the 5 liter water tank
 Remove the cap of the water tank opening and
add about 5 liter of water into the tank.
How to notice if there is enough water in the tank:
Fill in standby modus:
-
enough water, several beeps will sound.
After switching on:
-
the tank, the display shows [
As soon as enough water is available in the tank,
the symbol goes out and several beeps sound.
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not use multiple sockets or extension cords.
 It is not allowed to modify the plug provided with
the appliance! If the plug does not fit properly to
the outlet, let install a proper outlet by an author-
ized specialist.
 The accessibility of the power plug must always
be ensured to disconnect the device from the
power supply in case of an emergency.
 Make sure that the voltage supply matches the
specifications on the rating label (door frame) be-
fore connecting.
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
if the tank is filled with
if there is not enough water in
].

Using for the first Time

CAUTION:
 Use only salt and detergent for dishwashers. Oth-
er products may damage the unit.
 Always consider the dosage and storage recom-
mendations on the sales packaging.
WARNING:
Keep salt and detergent out of reach for children.
Filling salt into the salt container (water softener)
Water softener
The water hardness varies regionally. If hard water is
used in the dishwasher, deposits form on the dishes
and kitchen utensils. The appliance is equipped with
a water softener, that removes lime and minerals
from the water by using water softening in the salt
container. Your local water authority can advise you
on the hardness of the water in your area.
Adjusting the salt consumption
The salt consumption can be adjusted according to
your water hardness therefore optimally regulated.
 Turn on the appliance.
 Press the Program button for more than 5 sec-
onds, the setting mode is now activated for ap-
prox. 60 seconds.
 By repeatedly pressing the Program button, the
water hardness can be selected: H1->H2->H3
->H4->H5->H6. The display indicates the selec-
tion (see below table).
 The setting is automatically saved after a few
seconds; alternatively end the setup with the
Power button.
Water hardness
°dH Mmol/l
0-5 0-0.94
6-11 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
69
Setting → Salt cons. /
Display cycle
H1 0 g
H2 4 g
H3 8 g
H4 13 g