Télécharger Imprimer la page

BH FITNESS G-6445N Instructions De Montage Et Utilisation page 15

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
12 Your unit can only be used by one
person at a time. It can only be used
by people who weigh 115 kg or less.
13 Use the handrail to help you get on
and off the treadmill and when
changing the speed. Do not jump onto
the belt while it is moving.
14 Keep your hands well away from
any of the moving parts. Do not place
your hands, feet or any other object
below the treadmill belt.
15 Use suitable clothing and footwear.
Make sure that all laces/cords are tied
correctly.
To
unnecessary wear on the belt, make
sure that your footwear is not dirty.
16 It is not advisable to keep your unit
in a damp place for long periods as it
will be prone to rust.
17 Make sure not to overlubricate the
unit as this might stain the floor or
carpeting where the unit stands.
18 Do not stand still on the belt while it
is moving.
19 In the event of any emergency,
place your feet on the side rails and
hold onto the handrail until the unit
stops.
SAFETY INSTRUCTIONS.-
This product must have an earth
connection. In the event that the
appliance malfunctions then the earth
connection will redirect the electrical
current away from the machine and
reduce the risk of an electrical shock.
This product is supplied with a mains
cable that has an earth wire and a
plug with an earth pin. The plug must
only be used with an appropriate wall
socket,
installed
connected to earth, in accordance with
local regulations.
avoid
injury
correctly
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock. If in doubt, get an
electrician or technical specialist to
check that the earth connection is
correct. Do not modify the plug
supplied with the equipment, if it does
not fit the wall socket then get an
electrician to install an electrical
socket that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Figure
and
A. Make sure that the appliance is
only connected to a wall socket with
the same pin layout as the plug. Do
not use an adaptor with this appliance.
Always
recommendations
electrical appliances:
1 Make sure that the mains supply
voltage matches that of the machine
before plugging it in. The supply
voltage must be the same as that
stated on the characteristics plate and
the holes in wall socket must match
the pins for plug on the machine. Do
not use any type of adapter.
2 To reduce the risk of electrical
shock,
immediately after use and before
proceeding to clean it.
and
3 Only plug the machine into suitably
earthed wall sockets, as shown in
Figure A. An inadequate electrical
connection may result in electrical
shocks. If the plug is not suitable for
15
observe
the
when
always
unplug
following
using
the
unit

Publicité

loading