Troubleshooting - Ego Power+ PH1400 Guide D'utilisation

TROUBLESHOOTING

PROBLEM
Motor does not
run.
Motor runs, but
chain does not
rotate.
CAUSE
◾ ◾
The battery pack is not
attached to the pole saw.
◾ ◾
No electrical contact between
the saw and battery.
◾ ◾
The battery pack is depleted.
◾ ◾
The lock-off button is not
depressed before pressing
the trigger.
◾ ◾
The battery pack or power
head is too hot.
◾ ◾
Saw chain is bound in the
wood.
◾ ◾
Debris in bar groove.
◾ ◾
Debris in chain-sprocket
cover.
◾ ◾
Chain does not engage drive
sprocket.
SOLUTION
◾ ◾
Attach the battery pack to the pole
saw.
◾ ◾
Remove battery, check contacts and
reinstall the battery pack.
◾ ◾
Charge the battery pack.
◾ ◾
Press down the lock-off lever and
hold it, then depress the trigger to
turn on the pole saw.
◾ ◾
Allow the battery pack or power head
to cool until the temperature drops
below 152°F (67°C).
◾ ◾
Release the trigger; remove the saw
chain and guide bar from the wood,
then restart the pole saw.
◾ ◾
Press the saw chain against the
wood, move the pole saw back and
forth to discharge the debris.
◾ ◾
Remove battery pack, then remove
chain-sprocket cover and clean out
debris.
◾ ◾
Remove the battery pack and reinstall
the chain, making sure that the drive
links on the chain are fully seated on
the sprocket.
POLE SAW ATTACHMENT — PSA1000
33