Hose And Regulator Assembly And Replacement - for Living FHTS80021D Instructions D'assemblage

• Hand turn the manual gas control valve. Never use tools. If the valve will not turn by hand, do not try to
repair it. Call a certified gas technician. The use of force or any self-attempted repair may result in a fire or
explosion.
When connecting your gas cylinder:
Before connecting, be sure that there is no debris caught in the head of the gas cylinder, head of the
regulator valve or in the ports. Connect regulator valve and hand-tighten firmly. Disconnect the propane
cylinder from the regulator valve when the fire table is not in use. DO NOT obstruct the flow of combus-
tion air and ventilation air to the burner.

HOSE AND REGULATOR ASSEMBLY AND REPLACEMENT

1. This fire table comes equipped with a standard LP gas hose and regulator including the appliance side
connection for a CGA No 791 Cylinder Connection Device. The LP gas hose and regulator supplied with
this fire table must be used. Only a hose and regulator specified by manufacturer can be used for replace-
ment.
a. The CGA No 791 connection incorporates a magnetic flow limiting device that acts to limit the
flow of gas if a leak is detected between the regulator and the burner valve.
b. If the burner valve is open prior to the LP gas cylinder service valve being opened, the connec-
tion will interpret this free flow of gas to be a leak.
c. The connection safety feature will reduce gas flow from the regulator to the appliance to a mini-
mal level.
d. Be sure that the burner control valve is closed prior to opening the LP gas cylinder service valve
to ensure that the connection flow limiting device is not triggered mistakenly.
e. If the connection flow limiting device is triggered mistakenly, close the LP gas cylinder service
valve and the burner valve, wait 10 seconds to allow the device to reset, open the cylinder service
valve, then open the burner valve and light the fireplace as per lighting instructions.
2. Be sure to protect the hose from any hot surfaces. Serious danger may result if the hose contacts any
hot surface.
3. Regular maintenance of the hose and regulator:
a. Inspect the hose before each use of the fire table. If the hose shows signs of cracks, abrasions,
cuts or damage of any kind, do not operate the appliance. Fix or replace the hose as required
before using the appliance. For assistance with repair or replacement of the hose, call the service
centre at 1-877-483-6759. Use only replacement parts from the manufacturer.
b. Inspect the seal inside the CGA No 791 service valve on the LP gas cylinder when replacing the
cylinder or at least once per year. If there is any indication of damage, have the seal replaced by a
certified gas dealer before operating the appliance.
4. Do not use tools to tighten the CGA No 791 connection nut onto the LP gas cylinder service valve. Hand
tighten only.
5. Be careful to not cross the threads on the connection when tightening the CGA No 791 connection onto
the LP gas cylinder service valve.
6. "Leak Test" should always be performed after attaching the connection to the LP gas cylinder service
valve. See "Checking for Leaks" section of this manual in Step 12, page 24.
7. Connection instructions are on pages 20–21 (Steps 9–10 in Assembly section).
9