for Living FHTS80021D Instructions D'assemblage page 27

WARNING: NEVER light the burner
with the cover on the outdoor fireplace.
CAUTION: Keep outdoor gas appliance
area clear and free from combustible
materials, gasoline and other flammable
vapours and liquids.
CAUTION: Do NOT obstruct the flow of combustion and ventilation air.
CAUTION: Check and clean burner/venturi tubes for insects and insect nests. A clogged tube can lead
to a fire.
LIGHTING
1. Make sure all labels, packaging and protective films have been removed from the outdoor
fireplace.
2. Remove cover and burner lid (if applicable) before operating fireplace. Check for obstruc-
tions of airflow to the burner. Spiders, insects and webs can clog the burner/venturi tube. A
clogged burner tube can lead to a fire.
3. Control knob must be in the "OFF" position.
4. To ensure proper function, the screen on the pilot housing should not be covered by lava
rocks.
5. Connect LP gas tank per Steps 9 and 10.
6. Turn LP gas tank valve to "OPEN".
7. Push and hold the flame ignitor to create sparks within the electrode; and continue to hold.
8. Push in the switch knob and turn to the "ON" position. Keep holding down the switch knob to
allow gas to flow for 20 seconds.
9. After 20 seconds, release and turn control knob counter-clockwise to adjust flame to desired
height.
10. If ignition does not occur in 20 seconds turn burner switch knob to "OFF", wait five minutes,
fan with a newspaper or magazine, and repeat lighting procedure.
PROPER FLAME HEIGHT
15 1/2 to 23 1/2"
(40 to 60 cm)
27