for Living FHTS80021D Instructions D'assemblage page 31

Out of gas
Sudden drop
in gas flow or
Overfilling prevention device
reduced flame
may have been activated
height
Irregular flame
pattern flame
No gas flow
does not run
the full length
of burner
New burner may have
residual manufacturing oils
Spider webs or insect nest in
Flame is yellow
burner/venturi tube
or orange
Poor alignment of valve to
burner/venturi tube
High or gusting winds
Low on LP gas
Flame goes
out
Excess flow valve tripped
Flashback (fire
Burner and/or burner/
in venturi/
venturi tube is blocked
burner tube(s))
Flame seems to
Ice has built up on the
lose heat when
outside of the LP gas
burning in cold
tank because the
weather — tem-
vapourization process
perature below
is too slow
50°F (10°C)
Exchange, refill or replace LP gas tank
1. Turn control knob to "OFF"
2. Wait 30 seconds and light outdoor fireplace per
"Lighting" section
3. If flames are still too low, reset the overfilling
prevention device:
a. Turn control knob to "OFF"
b. Turn LP gas tank valve to "CLOSED"
c. Disconnect regulator
d. Turn control knob to "ON"
e. Wait one minute
f. Turn control knob to "OFF"
g. Reconnect regulator and leak check
connections, being careful not to fully open valve
h. Light outdoor fireplace per "Lighting" section
Exchange, refill or replace LP gas tank
Burn outdoor fireplace for 15 minutes and
reinspect
Clean burner/venturi tube
Ensure burner/venturi tube is properl
engaged with valve
Do not use outdoor fireplace in high winds
Exchange, refill or replace LP gas tank
Refer to "Sudden drop in gas flow or reduced
flame height"
Clean burner and/or burner/venturi tube
1. Turn off per "Turning Off" section
2. Replace with a spare LP gas tank
3. Reconnect LP gas tank per "Installing LP Gas
Tank" section
4. Follow "Checking for Leaks" section
5. Light outdoor fireplace per "Lighting" section
30 31 30