To reinstall the door
Warming drawer
Manual User_NX58H9500WS_DG68-00566A-01_EN_NonPF.indd 60
1. Firmly grasp both sides of the door at the top.
2. With the door set at the same angle as the
removal position (about 5 degrees from
vertical), slide the hinge arms into the hinge
slots at the bottom of the door.
3. Open the door fully. If you cannot open the
door fully, the hinge arms are not properly in
the hinge slots.
4. Lock the hinge arms by pushing them up
against the front frame of the oven.
5. Close the door, and make sure it opens and
closes normally.
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either side.
Take the drawer by both hands. Pull down
the left clip while lifting up the right clip to
remove the drawer.
3. Clean the drawer in warm, soapy water using
a cloth or soft brush. Then, rinse and dry it
thoroughly.
4. Put the drawer in the roller guides on either
side, and then snap the clips into place.
English - 60
2014-07-30
1:02:17