Publicité
Assembly / Setup
Optional flip-up shelf
étagère optionnelle relevable
estante plegable opcional
Installation
1. Determine which side of the lectern you want the shelf installed.
(Left or right).
2. Extend each shelf bracket to by depressing the release lever and
lifting until it locks into the 90° position. Figure 1.1.
3. Install the (4) lower 8-32 x 1/2" PH thread-cutting screws into the
side panel leaving about 1/4" of threads exposed.
4. Set the shelf assembly onto the (4) lower screws using the notched
brackets.
5. Secure the shelf assembly by installing the (4) upper 8-32 x 1/2" PH
thread-cutting screws.
6. Tighten all screws securely.
7. Install 2" grommet.
Inspiration Lectern
2" Grommet
8-32 x 1/2" PH
thread-cutting screws
(Install lower 4 first)
Montage / Câblage
Installation video available
See www.spectrumfurniture.com
The shelf will automatically lock into place when lifted into the horizontal
position with the levers released. Figure 1.2. To lower or flip-up the shelf,
press and hold the shelf bracket levers while slowly lowering or raising the
shelf. Do not move the lectern while the shelf is in the horizontal position.
Note: Power and communication wiring for document cameras, laptop
computers, and / or projectors placed on the flip-up shelf should be
routed on top of the audience-side of the shelf. Use of the shelf grommet
hole for wiring will result in pinching of the cords when the shelf is folded.
Keep clear of pinch points during shelf movement.
Flip-up shelf
Do not exceed 35 lb [15.9 kg] of weight on shelf.
assembly
Figure 1.1
Montaje e instalación
(1) 039622
2" Grommet
(1) 0119259
(8) 0100167
Flip-up shelf
8-32 x 1/2" PH
assembly
Thread-cutting screw
Operation
CAUTION
Release lever
(press here)
Folding shelf
bracket
0119411R4 Page 3 of 17
Figure 1.2
Publicité
