Select Step Frequency; Lockout Preprogram Frequency; Lockout Favourite Channel - Albrecht AE33 H Mode D'emploi

OPERATION

SELECT STEP FREQUENCY

You can change the steps of VHF-Low, FM, Aircraft, VHF-High and UHF
bank.
Press (Srvc) until a bank you want to change appears.
1.
2. Press (Stp) until a step mode appears.
3. Use the ▲/▼ to select steps from Auto / 5.0 / 6.25 / 10.0 / 12.5
kHz (The Step for Aircraft bank is 8.33 or 12.5 kHz.)
4. Press (Clr) or (Stp) or wait for 2 seconds to return to the mode
you were in.
LOCKOUT PREPROGRAMMED FREQUENCY
You can skip up to 40 specified frequencies during a Service scan. This lets
you avoid unwanted frequencies in Service Scan Mode.
To skip a frequency
•
Press (L/O) when the scanner stops on the frequency in Service
Scan Mode or when you have selected frequency manually in
Service scan hold mode. L/O appears.
To cancel skip for a single frequency
•
Manually select the frequency, then (L/O). L/O disappears.
To cancel all skip frequencies
•
Press (Hold) to stop scanning in Service scan hold mode, then
press & hold (L/O). A confirmation tone sounds.

LOCKOUT FAVOURITE CHANNEL

You can increase the scanning speed by locking out channels that you do
not like or which have a continuous transmission for all the channels in
favourite channel memory.
To lock out a channel
•
Manually select the channel, then press (L/O). L/O appears.
Note: You can still manually select locked-out channels.
To remove the lockout from a channel
•
Manually select the channel, then press (L/O). L/O disappears.
48 English