Network Menu; Pairing Sub-Menu; Configuration Sub-Menu - Tractel dynafor HHD Mode D'emploi

The language is selected by briefly pressing the "OK"
button when the wished language is highlighted.
The language
GB
instantaneously after selection. The product then
returns to the main menu.
To return to the main menu, hold down (for one second)
the left button.

5.5.11. Network menu

§5.5.11
The "Network" screen is entered by pressing the "OK"
button briefly (item E, fig. 1) when the "Network" icon is
highlighted from the main menu.
A
A "Pairing" sub-menu (see 5.5.11.1)
B "Configuration" sub-menu (see 5.5.11.2)
To return to the main menu, hold down (for one second)
the left button.

5.5.11.1. Pairing sub-menu

NB: This sub-menu also allows you to pair
display devices (dynafor™ HHD) configured in slave
mode. (See 5.5.18.)
The "Pairing" sub-menu is entered by pressing the "OK"
button briefly (item E, fig. 1) when the "Pairing" icon is
highlighted.
The product searches for one minute for devices in
its environment. If another master display device is
present, the product increments its channel, up to a
limit of 10 channels. Beyond that, pairing will not be
possible.
NB: It is not possible to pair a sensor already
paired and switched on with another display device. It
will not appear in the list of sensors.
NB: No more than four sensors and three slave
display devices can be paired. For this, the PC option
is required.
14
§5.5.11.1 & §5.5.1
is changed automatically and
A B
A List of sensors or slave devices found
B Nature of the sensor (dynafor™ Pro, Expert,
B
Transmitter) or display unit (dynafor™ HHD)
C Identification of equipment (last nine digits in serial
number)
D Sensor capacity in t
E "Select all" button
The navigation is done by using the up and down arrow
buttons. (See figure 1.) Sensors that are not paired are
ticked red by default.
Pressing the "OK" button (see figure 1) selects the
sensor for pairing. The tick will then turn green.
Pressing the "OK" button of a sensor already paired
(green tick) changes the tick to red. The sensor will then
be unpaired during the validation stage.
All sensors can be selected by pressing the "OK" button
when "Select all" is selected and highlighted.
After selecting them all, holding down the "OK" button
starts the pairing of the sensors.
The pairing of a sensor is confirmed when the two
LEDs on the front of the sensor are activated for three
continuous seconds.
Once the sensor(s) have been paired, the product
automatically switches to the main display.
To return to the main menu, hold down (for one second)
the left button. In this case, no changes are made to the
current configuration.

5.5.11.2. Configuration sub-menu

NB: A sensor is always configured in slave
mode. See chapter 5.5.18 for details on pairing other
display devices in slave mode.
C E D