Code Learning - Nemaxx WLS-01 Mode D'emploi

CODE LEARNING

1. Turn the awning on. The awning will open 1cm, then close.
2. Push the learning button on the wind sensor once.
3. The awning will open 1cm then close.
This means the learning process was successful.
SET WIND THRESHOLD
1. Press the left button for 2 seconds and the left numbers on the LCD will blink.
2. Press the left button again and the numbers will change from 0 to 5.
3. Select the figure you want and then press the right button one time to exit the setting.
The numbers stop blinking and the wind threshold is set.
Wind Threshold Corresponding to Actual Wind Speed
1
Wind Threshold
0
1
2
3
4
5
EN
1
Wind speed
deactivated
10 km/h
15 km/h
20 km/h
30 km/h
> 40 km/h
6
KEN001WLS
v01 • 17.05.2017
1
1