Data Copying - Alcad 905-TO Série Manuel D'installation Et Programmation

30 - ENG
To transmit, press the T key. The programming led will blink to indicate that
the receiver has received the data. Besides, the data transmitted will be
stored in the PS programmer.
5.3 OSD Language, output channel and output frequency
selection
Select the language on the PS programmer and in the OSD menu, pressing
F LANG. and F for confirming.
When the
Output channel B/G CCIR C
programmer screen, you could select standard channels meanwhile when
the
Output channel B/G CCIR S
S band channels. Press the C/S key to switch between standard channels
and S band channels.
When
Frequency
output frequency with a resolution of ±0,25 MHz.
The language transmission is made altogether with the TO output channel
transmission.
To change standard or move to frequency mode, select
channel B/G CCIR C
screen you are viewing, then press the " to open the submenu. Using the
& or ', you can select the desired standard or frequency mode. Press the
! to confirm your selection and to continue programming the module.
WARNING, receivers are adjusted ex works to channel S-41. We
recommend using a previous planning of output channels or output
frequency and a further noting down in the receiver box before
programming, thus avoiding the selection of already engaged channels.
Make sure that the output channels or output frequency are not being used
in the distribution. Nevertheless, to verify the output channel or output
frequency programmed in the TO receivers that are not properly noted
down, use the READ function.
6.

DATA COPYING

The COPY function is provided, to avoid transmitting the TO module data
one by one. Aiming at the transmodulator, press the F and COPY keys. The
PS programmer must be kept aimed at the receiver until the
message is deleted from the screen. The programming led will blink while
transmitting and all the data, except the output channel and the OSD
language will be sent.
Installation and programming manual
is displayed on the screen, you could select the
or
is displayed you could select
Frequency
is displayed in the PS
Output
, depending on which
Copy...