Sending Data To The To Transmodulator; Programming Mode - Alcad 905-TO Série Manuel D'installation Et Programmation

SCREEN
Data error
Reading error An error occurred during the READ function.
5.

SENDING DATA TO THE TO TRANSMODULATOR

5.1

Programming Mode

For a transmodulator to be programmed, the 'Program' switch (24) must be
switched ON; as this is done, the 'Programming' indicator turns on. While
the indicator is lit, the transmodulator is ready to receive data from the PS
programmer.
On the screen of the level meter will come out the OSD (On Screen Display)
menu of the transmodulator.
Once the transmodulator has been programmed, the Programming Mode
has to be disabled by switching OFF the 'Program' switch. The
'Programming' indicator turns off. The programming indicator will turn off,
the screen of the level meter will come black and after a few seconds the
picture of the selected TV program will be on screen.
5.2 Data Transmission
Select the desired function on the PS programmer screen and adjust the right
value of that function.
Serie 905-TO
DESCRIPTION
The data selected does not belong to the range of
values indicated in table 3.
Tab. 4 - Warnings
Fig. 9 - Program mode
TO-551
ENG - 29