Spin Only Adjustment; My Cycle - Samsung WA5471AB Série Manuel D'utilisation

washing a load of laundry

Spin Only Adjustment

If you press the Power button, and then press and hold the Spin button for 2 seconds, the spin
time is displayed on the display panel.
You can then change the spin level independently of any other setting by pressing the Spin
button repeatedly until the spin level you want (High, Medium, etc.) is selected on the control
panel. Then, press the Start/Pause button.
Make a Spin Only adjustment before you select a cycle. If you have selected a cycle, you
can only select the corresponding spin level.
Garment+
You can add or take out laundry items even after the wash has started, as long as the
"Garment+" light is on. Pushing the Start/Pause button unlocks the door, unless the water is
too hot or there is too much water in your Washer. If you open the door and want to continue the
wash cycle, close the door, and then press the Start/Pause button.
If you have activated Child Lock, you must deactivate it fi rst. See page 21

My cycle

My Cycle lets you create a custom wash cycle (with custom temperature, spin, soil level, etc.)
and activate your custom wash cycle with one–button convenience.
Creating a custom wash cycle
To create a custom wash cycle, follow these steps:
1. Press the Power button, and then open the door.
2. Load the washer with clothes.
3. Add detergent (and softener and/or bleach if needed) to the appropriate compartments, and
then close the door.
4. Press the My Cycle button. The My Cycle indicator light illuminates.
5. Select the cycle you want on the Cycle Selector dial.
6. Set the options available for the cycle you selected.
See pages 34~35 for the options available with each cycle.
7. Push the Start/Pause button to start the cycle. The next time you press My Cycle, the washer
will return to these settings automatically.
To program in "My Cycle" settings, the washer needs to complete an entire wash cycle. If
for any reason the wash cycle is interrupted and the washer does not fi nish the cycle, it will
not program in the settings for later use.
You can change the "My Cycle" settings by repeating the process above. The washer uses
the latest programmed settings whenever you choose "My Cycle".
Running your custom cycle using My Cycle
To run your custom cycle, follow these steps:
1. Press the Power button, and then open the door.
2. Load the washer with clothes.
3. Add detergent (and softener and/or bleach if needed) to the appropriate compartments, and
then close the door.
4. Press the My Cycle button. The My Cycle indicator light illuminates and the cycle begins.
22_ washing a load of laundry
WA5471ABP-03050A-03_EN.indd Sec5:22 WA5471ABP-03050A-03_EN.indd Sec5:22 2012-02-02 2012-02-02 6:23:38 6:23:38