Samsung WA5471AB Série Manuel D'utilisation page 16

installing your washer
2. Check the inlet hoses to ensure a washer is inside the
coupling of each fi ll hose.
Thread the inlet hoses onto the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber washer
per hose and attach each fi ll hose to the water valve. Make
sure the hose with Hot printed on it is attached to the HOT
faucet. Tighten by hand until snug, then add two-thirds of a
turn with pliers.
For correct water use, connect both HOT and COLD water
valves. If either or both are not connected, an "nF" (no fi ll)
error can occur.
3. Turn on the "HOT" and "COLD" water supplies and check all
the water valve and the faucet connections for leaks.
4. Plug the power cord into a 3-Prong, well grounded 120 volt
60 Hz approved electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third prong of the
power cord when plugged into a three-prong grounded
receptacle.
5. Slide your washer into position.
6. Level your washer by turning the leveling legs in or out as
necessary by hand.
See if the machine is placed level by checking the position
of the washing tub.
• Open the lid of the machine, pour water into the tub up
to the level just below the pulsator, and adjust the legs so
that the pulsator is positioned at the center of the water as
shown in the fi gure.
• Place the machine more than 10 cm away from the wall.
• Adjust the legs on feet for levelling.
16_ installing your washer
WA5471ABP-03050A-03_EN.indd Sec3:16 WA5471ABP-03050A-03_EN.indd Sec3:16
Cold Hot
Rubber Washer
Cold printed Hot printed
Water
LOOSEN
LOCK
2012-02-02 2012-02-02 6:23:37 6:23:37