Connecting The Battery - Tripp-Lite SmartPro 2U Manuel Du Propriétaire

Connecting the Battery

The UPS is shipped with the battery disconnected. The battery must be connected for the UPS to
operate. This should be done prior to connecting the UPS to AC mains or connecting any
equipment to the UPS. Follow the installation procedure below:
1
Remove Front Panel
1
4 x screws
3
Connect Batteries
3
5
Replace Front Panel
5 4 x screws
18-05-315-933848.indb 4
2
Remove Battery Retention Plate
2 4 x screws
4
Replace Battery Retention Plate
4 4 x screws
4
7/9/2018 11:22:49 AM